Car # 68 - Friday - 08/28/20

Took all of the Top Block off the car and cleaned and removed all of the brick shards

Moved Center Supports back into position and replaced 2 broken Parimitor Corner blocks

Re-leveled 5 other parimitor Blocks and Replaced all the KOA wool expansion joints

Replaced all broken Top Block on Car with good Blocks off of several other cars

Set all the Top Block in Precise Position and installed KOA wool for Expansion Joints

Put 2 Expansion Joints Vertical and Horizontally to allow for block compression inside the Kiln

Put all 48 Brick Support Block on Top and arranged them to fit the setter for Efficiency

Straightened out Left Front and Rear Bottom Skirt and Right Front Bottom Skirt so they go through the Kiln

Painted all 8 sides of all 4 of the Corner Blocks and Painted Number 68 on all 8 sides

Jacked up all 4 corners 1 at a time , filled each wheel with grease and checked to make sure they turned freely


Car #68 After